Aligning Layers (Layer-to-Layer Alignment) - LAB

The layers and drills have been deliberately offset.


First we’ll align layer 1 with layer 2 using Edit/Layers > Align.


Turn off all but layers 1 and 2. 
(These layers should be CAM_DemoL1.PHO and CAM_DemoL2.PHO respectively).

• CAM_DemoNC3-4.DNote the instructions in the Command Status area of the Status Bar that will assist you in stepping through this procedure.

•  Make sure the “Snap to Object” (“Z”) button is pressed on the Status Bar.

Select the lower left mounting hole on layer 2. 

Click on the object using the LMB (Left mouse button) then “Commit” to this selection by clicking the RMB (right mouse button.).

• Note how the “Page Up” and “Page Down” keys can be used to increase or decrease the “pick” area of the cursor.

• Note that layers may be freely turned on or off to facilitate selection.

Select the complimentary object on the layer to be aligned with the LMB then commit to the object with the RMB.

• Note the fact that this procedure cannot be undone. 

A warning message allows an opportunity to abort if necessary.


Clicking the RMB a second time completes the operation aligning the two layers.